Measured-value memory, current output
F
F
If the measured-value memory is switched on,
the last measured value is stored when the CAL
key is pressed. It is then present at the mA output
until the analyzer is reset to the measurement
status by pressing the MEAS key.
The measured value is also stored in the display
in the event of an error.
Factory setting: 0
** 21 Measured-value memory on/off
Off
On
0
2
1
CL
1
Status
0 0 to 20 mA
1 2 to 20 mA
2 4 to 20 mA
Factory setting: 2
CL
4
Status
2
** 24 Set current output
A-25
To Next Page
Loading...
