Siemens G130 - r9900 Actual topology number of indices; Act topo indices; r9901[0...n] Actual topology; Act topo

To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G130/G150

1012 List Manual (LH2), 07/2016, A5E03263479A

Description: Displays the number of indices of the actual topology.

Dependency: Refer to: r9901

Note: Only for internal Siemens use.

The parameter is not displayed for the STARTER commissioning software.

Description: Displays the actual topology of the drive unit.

The actual topology is sub-divided into several sections. Each of the following data is saved under an index.

General data on the topology:

- version

- attribute to compare the actual topology and target topology

- number of components

Data on a component:

- type component of the node ID of the component

- number of DRIVE-CLiQ sockets in the Node Identifier

- manufacturer and version of the Node Identifier

- serial number of the Node Identifier (4 indices)

- index of the component

- article number (8 indices)

- attribute to compare the actual topology and target topology of the component

- communications address

- number of port types

- port type

- number of ports of the port type

- communications address of the associated/linked component

- number of the associated/linked port

- communications address of the associated/linked component

- number of the associated port, etc.

Data on the next component:

- etc.

Dependency: Refer to: r9900

Note: Only for internal Siemens use.

The parameter is not displayed for the STARTER commissioning software.

r9900 Actual topology number of indices / Act topo indices

CU_G130_PN,

CU_G150_PN,

CU_G130_DP,

CU_G150_DP

Can be changed: - Calculated: - Access level: 3

Data type: Unsigned16 Dyn. index: - Func. diagram: -

P-Group: Topology Unit group: - Unit selection: -

Not for motor type: - Scaling: - Expert list: 0

Min Max Factory setting

- - -

r9901[0...n] Actual topology / Act topo