Siemens G130 - p10062 SI TM54 F password new; SI password new; p10063 SI TM54 F password acknowledgment; SI ackn password; p10070 SI TM54 F module identifier; SI module ID; r10090[0...3] SI TM54 F version; SI Version

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
1059
2 Parameters
2.2 List of parameters
Description: Enters the new Safety Integrated password for the Terminal Module 54F (TM54F).
Dependency: A change made to the Safety Integrated password must be acknowledged in the following parameter:
Refer to: p10063
Description: Acknowledgment of the new Safety Integrated password for the Terminal Module 54F (TM54F).
Dependency: Refer to: p10062
Note: The new password entered into p10062 must be re-entered in order to acknowledge.
p10062 = p10063 = 0 is automatically set after the new Safety Integrated password has been successfully
acknowledged.
Description: CRC via Node Identifier of the TM54F
Description: Displays the Safety Integrated version for the Terminal Module 54F (TM54F).
Index: [0] = Safety Version (major release)
[1] = Safety Version (minor release)
[2] = Safety Version (baselevel or patch)
[3] = Safety Version (hotfix)
Dependency: Refer to: r9390, r9590, r9770, r9870, r9890
Note: Example:
r10090[0] = 2, r10090[1] = 60, r10090[2] = 1, r10090[3] = 0 --> SI TM54F version V02.60.01.00
p10062 SI TM54F password new / SI password new
TM54F_MA,
TM54F_SL
Can be changed: C2(95) Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2891
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
p10063 SI TM54F password acknowledgment / SI ackn password
TM54F_MA,
TM54F_SL
Can be changed: C2(95) Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2891
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
p10070 SI TM54F module identifier / SI module ID
TM54F_MA Can be changed: C2(95), T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
r10090[0...3] SI TM54F version / SI Version
TM54F_MA,
TM54F_SL
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -