Siemens G130 - p1845[0...n] Actual value correction evaluation factor Lsig; ActVal_cor ev Lsig; p1846[0...n] Actual value correction damping factor; ActV_corr D_factor; r1848[0...5] Actual value correction phase currents; ActVal_corr I_ph; r1849[0...5] Actual value correction phase voltages; ActVal_corr U_ph

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
471
2 Parameters
2.2 List of parameters
Description: Sets the weighting factor for the leakage inductance of the L-R element of the actual value correction.
Dependency: Refer to: p0391, p0392, p0393
Note: The load-dependent adaptation of the leakage inductance of the current actual value correction is defined using
p0391 ... p0393.
Description: Sets the damping factor for the actual value correction.
The factor multiplies the T0/Tsig ratio in the feedback branch of the LR element.
Description: Displays phase correction currents as well as the drive converter phase currents
Index: [0] = Harmonics phase U
[1] = Harmonics phase V
[2] = Harmonics phase W
[3] = Measured value phase U
[4] = Measured value phase V
[5] = Measured value phase W
Description: Displays the phase correction voltages and and the drive converter phase voltages
Index: [0] = Harmonics phase U
[1] = Harmonics phase V
[2] = Harmonics phase W
[3] = Measured value phase U
[4] = Measured value phase V
[5] = Measured value phase W
p1845[0...n] Actual value correction evaluation factor Lsig / ActVal_cor ev Lsig
VECTOR_G Can be changed: U, T Calculated: - Access level: 4
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: -
P-Group: Modulation Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0.00 10.00 1.00
p1846[0...n] Actual value correction damping factor / ActV_corr D_factor
VECTOR_G Can be changed: U, T Calculated: - Access level: 4
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: -
P-Group: Modulation Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0.00 10.00 1.00
r1848[0...5] Actual value correction phase currents / ActVal_corr I_ph
VECTOR_G Can be changed: - Calculated: - Access level: 4
Data type: FloatingPoint32 Dyn. index: - Func. diagram: -
P-Group: Modulation Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r1849[0...5] Actual value correction phase voltages / ActVal_corr U_ph
VECTOR_G Can be changed: - Calculated: - Access level: 4
Data type: FloatingPoint32 Dyn. index: - Func. diagram: -
P-Group: Modulation Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -