Siemens G130 - Page 6

Preface
SINAMICS G130/G150
6 List Manual (LH2), 07/2016, A5E03263479A
Usage phases and their tools/documents (as an example)
Target group
This documentation addresses machine manufacturers, commissioning engineers, and
service personnel who use SINAMICS.
Benefits
This documentation contains comprehensive information about parameters, function diagrams
and faults and alarms required to commission and service the system.
This manual should be used in addition to the other manuals and tools provided for the product.
Table V-1 Usage phases and the available tools/documents
Usage phase Tools/documents
Orientation SINAMICS G Sales Documentation
Planning/configuring SIZER Engineering Tool
Configuration Manuals, Motors
Deciding/ordering SINAMICS G Catalogs
Installation/assembly • SINAMICS G150 Operating Instructions
• SINAMICS G130 Operating Instructions
Commissioning • STARTER Commissioning Tool
• SINAMICS G150 Operating Instructions
• SINAMICS G130 Operating Instructions
Usage/operation • SINAMICS G150 Operating Instructions
• SINAMICS G130 Operating Instructions
Maintenance/servicing • SINAMICS G150 Operating Instructions
• SINAMICS G130 Operating Instructions