Siemens G130 - p4038 BI: TM31 signal source for terminal DI;DO 8; TM31 s_s DI;DO8; p4039 BI: TM31 signal source for terminal DI;DO 9; TM31 S_src DI;DO9; p4040 BI: TM31 signal source for terminal DI;DO 10; TM31 S_src DI;DO10; p4041 BI: TM31 signal source for terminal DI;DO 11; TM31 s_s DI;DO 11

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
645
2 Parameters
2.2 List of parameters
Description: Sets the signal source for terminal DI/DO 8 (X541.2) of Terminal Module 31 (TM31).
Note: Prerequisite: The DI/DO must be set as an output (p4028.8 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 9 (X541.3) of Terminal Module 31 (TM31).
Note: Prerequisite: The DI/DO must be set as an output (p4028.9 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 10 (X541.4) of Terminal Module 31 (TM31).
Note: Prerequisite: The DI/DO must be set as an output (p4028.10 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 11 (X541.5) of Terminal Module 31 (TM31).
Note: Prerequisite: The DI/DO must be set as an output (p4028.11 = 1).
DI/DO: Bidirectional Digital Input/Output
p4038 BI: TM31 signal source for terminal DI/DO 8 / TM31 s_s DI/DO8
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9549, 9560
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p4039 BI: TM31 signal source for terminal DI/DO 9 / TM31 S_src DI/DO9
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9560
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p4040 BI: TM31 signal source for terminal DI/DO 10 / TM31 S_src DI/DO10
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9562
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p4041 BI: TM31 signal source for terminal DI/DO 11 / TM31 s_s DI/DO 11
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9549, 9562
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0