Siemens G130 - p6996[0...63] Recorder signals; Rec sig; r6997 CO: Recorder sequencer state; Rec state

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
749
2 Parameters
2.2 List of parameters
Description: Setting to parameterize the signals for the recorder.
Description: Display and connector output of the state of the sequencer for the recorder.
Value: 0: Not active
10: Active
20: Post trigger time running
30: Prepare data save operation
40: Start data save
50: End data save
60: Configuration
p6996[0...63] Recorder signals / Rec sig
B_INF (Rec) Can be changed: U, T Calculated: - Access level: 4
Data type: Unsigned32 Dyn. index: - Func. diagram: 8144
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 996553699 [0] 3600
[1] 3700
[2] 3701
[3] 3703
[4] 3711
[5] 3712
[6] 6600
[7] 6800
[8] 7000
[9] 8200
[10] 9400
[11] 89800
[12] 89900
[13] 7200
[14] 183800
[15] 183900
[16] 723000
[17] 723001
[18] 703100
[19...63] 0
r6997 CO: Recorder sequencer state / Rec state
VECTOR_G (Rec),
B_INF (Rec)
Can be changed: - Calculated: - Access level: 4
Data type: Integer16 Dyn. index: - Func. diagram: 8145
P-Group: Closed-loop control Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 60 -