Siemens G130 - r8890.0...15 BO: IF2 PZD1 receive bit-serial; IF2 PZD1 recv bitw; r8891.0...15 BO: IF2 PZD2 receive bit-serial; IF2 PZD2 recv bitw

To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G130/G150

872 List Manual (LH2), 07/2016, A5E03263479A

Dependency: Refer to: p8851, p8880, p8881, p8882, p8883, p8884, p8888

Note: r8889 together with p8880 to p8884 forms five binector-connector converters.

Description: Binector output for bit-serial interconnection of PZD1 (normally control word 1) received via interface 2.

Dependency: Refer to: r8850

Note: IF2: Interface 2

Description: Binector output for bit-serial interconnection of PZD2 received via interface 2.

11 Bit 11 ON OFF -

12 Bit 12 ON OFF -

13 Bit 13 ON OFF -

14 Bit 14 ON OFF -

15 Bit 15 ON OFF -

r8890.0...15 BO: IF2 PZD1 receive bit-serial / IF2 PZD1 recv bitw

CU_G130_PN,

CU_G150_PN,

CU_G130_DP,

CU_G150_DP,

VECTOR_G, B_INF,

TM31, TM120, TM150,

TB30, ENC

Can be changed: - Calculated: - Access level: 3

Data type: Unsigned16 Dyn. index: - Func. diagram: 2485, 2491,

9204, 9206

P-Group: Communications Unit group: - Unit selection: -

Not for motor type: - Scaling: - Expert list: 1

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Bit 0 ON OFF -

01 Bit 1 ON OFF -

02 Bit 2 ON OFF -

03 Bit 3 ON OFF -

04 Bit 4 ON OFF -

05 Bit 5 ON OFF -

06 Bit 6 ON OFF -

07 Bit 7 ON OFF -

08 Bit 8 ON OFF -

09 Bit 9 ON OFF -

10 Bit 10 ON OFF -