Siemens G130 - r8930[0...239] PN Name of Station actual; PN Name Stat act; r8931[0...3] PN IP address actual; PN IP addr act; r8932[0...3] PN Default Gateway actual; PN Def Gateway act; r8933[0...3] PN Subnet Mask actual; PN Subnet Mask act

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
882 List Manual (LH2), 07/2016, A5E03263479A
Description: Displays the actual station name for the onboard PROFINET interface on the Control Unit.
Description: Displays the actual IP address for the onboard PROFINET interface on the Control Unit.
Description: Displays the actual default gateway for the onboard PROFINET interface on the Control Unit.
Description: Displays the actual subnet mask for the onboard PROFINET interface on the Control Unit.
Description: Displays the actual DHCP mode for the onboard PROFINET interface on the Control Unit.
Value: 0: DHCP off
2: DHCP on, identification using MAC address
3: DHCP on, identification via name of station
Notice: When the DHCP mode is active (parameter value not equal to 0), PROFINET communication via this interface is no
longer possible! However, the interface can be used for commissioning tool such as STARTER or SCOUT.
r8930[0...239] PN Name of Station actual / PN Name Stat act
CU_G130_PN,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8931[0...3] PN IP address actual / PN IP addr act
CU_G130_PN,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -
r8932[0...3] PN Default Gateway actual / PN Def Gateway act
CU_G130_PN,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -
r8933[0...3] PN Subnet Mask actual / PN Subnet Mask act
CU_G130_PN,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -
r8934 PN DHCP Mode actual / PN DHCP Mode act
CU_G130_PN,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 3 -