Siemens G130 - p9318 SI Motion encoder pulses per revolution (Motor Module); SI Mtn p;rev MM; p9319 SI Motion fine resolution G1_XIST1 (Motor Module); SI Mtn G1_XIST1 MM; p9320 SI Motion spindle pitch (Motor Module); SI Mtn sp_pitch MM

SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
899
2 Parameters
2.2 List of parameters
Description: Sets the number of encoder pulses per revolution for rotary encoders.
The encoder that is used for the safe motion monitoring functions on the Motor Module/Hydraulic Module must be
parameterized in this parameter.
Dependency: Refer to: p0408, p9316
Description: Sets the fine resolution for G1_XIST1 in bits.
The encoder that is used for the safe motion monitoring functions on the Motor Module/Hydraulic Module must be
parameterized in this parameter.
Dependency: Refer to: p0418
Refer to: F01670, F01671
Note: For safety functions that have not been enabled (p9301 = 0), the following applies: When booting, p9319 is
automatically set the same as p0418.
For safety functions that are enabled (p9301 > 0), the following applies: p9319 is checked for agreement with p0418.
G1_XIST1: Encoder 1 position actual value 1 (PROFIdrive)
Description: Sets the gear ratio between the encoder and load in mm/revolution for a linear axis with rotary encoder.
The encoder that is used for the safe motion monitoring functions on the Motor Module/Hydraulic Module must be
parameterized in this parameter.
Dependency: Refer to: p9520
Notice: The fourth decimal point can be rounded-off depending on the size of the entered number (from 3 places before the
decimal point).
p9318 SI Motion encoder pulses per revolution (Motor Module) / SI Mtn p/rev MM
VECTOR_G Can be changed: C2(95) Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 16777215 2048
p9319 SI Motion fine resolution G1_XIST1 (Motor Module) / SI Mtn G1_XIST1 MM
VECTOR_G Can be changed: C2(95) Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
2 18 11
p9320 SI Motion spindle pitch (Motor Module) / SI Mtn sp_pitch MM
VECTOR_G Can be changed: C2(95) Calculated: - Access level: 3
Data type: FloatingPoint32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0.1000 [mm] 8388.0000 [mm] 10.0000 [mm]