Siemens Gigaset SX541 WLAN dsl - Network Configuration with Windows 98 SE, ME; Setting up a PC as a Client for Microsoft Networks

38
Configuring the Local Network
Gigaset SX541 WLAN dsl / englisch / A31008-M1025-L101-1-7619 / configure_tcpip.fm / 21.07.2005
Schablone 2005_05_02
Network Configuration with Windows 98 SE, ME
To integrate a PC with Windows 98 SE or ME in a local network, you must carry out the
following steps:
1. Set up the PC as a client for Microsoft networks (see below).
2. Select computer names and workgroup (see page 39).
3. Install the TCP/IP protocol (see page 40).
4. Make TCP/IP protocol settings (see page 41).
5. Deactivate the http proxy (see page 45).
6. Synchronise the TCP/IP settings with the Gigaset SX541 WLAN dsl
(see page 46).
Setting up a PC as a Client for Microsoft Networks
Before the PCs in your network can work together, you have to configure them as a
Microsoft network Client. This is done as follows:
ì Click Start – Settings – Control Panel.
ì Double-click the Network icon and then open the Configuration tab in the Net-
work window.
ì Check whether the list of components contains the entry Client for Microsoft Net-
works.
ì If it is not there click Add.