Siemens Hematek 3000 System - Page 70

Hematek
®
3000 System – Instruction Manual – Version 1.3127
7 Performing maintenance
7
14. Reach underneath the platen through the waste tank area, see
Figure 7-6.
15. Pull the rinse, buffer, and stain tubes free from behind the rear conveyor
spiral.
16. Disconnect the tubes from the spouts under the platen.
17. Dispose of the tubes.
18. If you want to install a new Hematek Underplaten Tubing Set, go to
Chapter 7.4.2, otherwise set the waste tank back in place.
1 Spouts
2 Rinse tube
3 Buffer tube
4 Stain tube
5 Rear conveyor spiral
6 Waste tank area
7 Platen
8 Slide drawer
Figure 7-6 Waste tank area, bottom view
7 5
1 2 1 13
8
6
4