Siemens Hicom 150 E Office - Page 13

8.8 Configuring an ISDN system interface
8.9 Configuring an ISDN multi-device connection with MSN no. assignment
8.10 Configuring Call Management with group call and call forwarding - no answer
8.11 Announcement before answering (on analog port)
8.12 Assigning incoming MSI calls
8.13 Configuring fixed night service
8.14 Configuring an intercept extension per line
8.15 CorNet networking
8.15.1 Networking Hicom 150 E Office with Hicom 150 E Office
8.15.2 Networking Hicom 300 with Hicom 150 E Office
8.15.3 Programming operations for all networking types
8.16 Configuring the boss/secretary function
8.17 Boss/secretary systems (TOP)
8.18 Configuring an internal S0 bus with multiple extensions
8.19 Configuring call pickup groups
8.20 Configuring a second V24 interface
8.21 Configuring an entrance telephone and entrance telephone ring destination
8.22 Configuring a door busy actuator
8.23 Programming a sensor as an alarm dialling device
8.24 Configuring Least Cost Routing (DICS)
8.25 Remote administration via ISDN
8.26 Remote administration via DTMF
8.27 Configuring Hicom cordless 150 E
8.28 Configuring TRG groups
8.29 Configuring hotline extensions
8.30 Configuring relocate
8.31 UCD - Universal Call Distribution
8.32 Hicom 150 E Office - Hicom Agentline Office call distribution
8.33 Configuring DISA
8.34 Configuring an AC
8.35 Routes
8.36 Tenant services
8.37 COS changeover after timeout
8.38 Analog tie traffic via TIEL boards
8.39 Mozart CD announcement device with start/stop contact at the TIEL board
Hicom 150 E Office Rel.1.0 Service Manual - Contents
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/index.htm (11 of 16) [06/04/2000 13:02:10]