Only one SLMC8 is installed in the system. The SLMC8 in the lowest slot is put into operation
if more than one SLMC8 is connected.
Assigning the subscriber line circuits and ports
Figure 4-19 Hicom 150 E OfficePro - starting up the subscriber line circuits and ports
Recommended configuration
The TMS2M and SLMC8 boards should be inserted in the BC or in the first two slots of the ECs to
prevent the B-channels from being blocked. Hicom Assistant E takes these rules into account when
performing off-line configuration.
Distributing the PCM sequence
The following diagrams show the PCM sequences (64 time multiplex channels) for the different
Hicom 150 E OfficePro system configurations.
Single-cabinet system: PCM sequence
Figure 4-20 PCM sequence of a single-cabinet system
Two-cabinet system: PCM sequence
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_4m.htm (24 of 27) [06/04/2000 13:04:41]
To Next Page
Loading...
