The printer must be turned off and on again in order for any changes to the settings made to
become effective.
The settings listed in the following table must be observed if using a different printer. Refer
to the operating instructions provided with the printer in question for more details.
Position of DIP switch series 1 and 2
Figure 6-5 P 500 printer - position of DIP switch series 1 and 2
DIP switch series 1
Table 6-2 P 500 printer - DIP switch series 1
Switch no. Function Switch setting
On Off
1-1
1-2
1-3
International characters see Table 6-3
1-4
1
Choice between EPSON and IBM mode IBM EPSON
1-5 Character set selection in IBM mode Char. set 2 Char. set 1
1-inch hole in EPSON mode Yes No
1-6 Page length 12 inches 11 inches
1-7
2
LF code selection in IBM mode LF+CR LF only
DC1/DC3 code selection in EPSON mode No Yes
1-8
3
CR code selection in IBM mode CR+LF CR only
CR code selection EPSON mode CR+LF
The default settings are highlighted in bold.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_6m.htm (10 of 14) [06/04/2000 13:05:06]
To Next Page
Loading...
