7. If necessary:
Feed lead seal wire through lower right-hand fastening hole of outdoor casing and lead seal
wire hole of mounting plate (see Figure 12-4). Seal wire.
BS mounting: outdoor casing, mounting plate, mast blocks
Figure 12-4 BS mounting - outdoor casing, mounting plate, mast blocks
Procedure (continued)
Step Action
8. Fix mounting plate and outdoor casing at the appropriate height on wood, plastic or cement
mast with metal tightening straps (see Figure 12-5).
9. Connect the BS (see Section 12.3.3).
10. Using adhesive tape, fix BS onto heating board plate (see Figure 12-6). Then place the BS and
heating board plate into the cavity provided in the outdoor casing. Ensure that it fits securely.
The heating board for regulating the temperature in the outdoor casing has not yet been
released for operation with Hicom cordless 150 E Version 1.0!
DO NOT connect the heating board! This could cause the system to malfunction due to
self-heating.
Step Action
11. Close outdoor casing cover using the four triangular head screws.
Hicom 150 E Office Rel.1.0 Service Manual - 12 Cordless Multicell Integration CMI
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_12.htm (7 of 45) [06/04/2000 13:05:55]
To Next Page
Loading...
