Siemens Hicom 150 E Office - Radio Tests; Checking the Radio Coverage

Replacing/disabling the mobile telephone
If a mobile telephone has to be replaced during a service intervention, the old mobile telephone must
be logged out before the replacement unit is logged in.
When replacing a mobile telephone, a new PIN must be assigned to the extension involved
in the Hicom 150 E OfficePro system. The mobile telephone is thus automatically logged
off.
Moreover, it is no longer possible to incorrectly log in a mobile telephone with the old PIN.
Assigning a new PIN with Hicom Assistant T
Step Entry Action Display
1. *95 31994 Start system administration System Administration
2. 36 Hicom cordless 150 E parameters Cordless
3.
2
Change the PIN for the 1st mobile telephone and thus
log out the current MT
Device 1: 11568
4.
* 11223
Enter the new PIN and thus log out the old MT Device 1: 11223
5. F8-F7 Exit system administration Set time, set date
6. Open the login window and start the login procedure at the MT as described.
Assigning a new PIN using Hicom Assistant E
Step Action
1. Options -> Set up station -> Station -> Station Parameter -> Type
2. Open the login window and start the login procedure at the MT as described (not possible with
Hicom Assistant E).
12.5 Radio tests
In general, a < 1 % reduction in the quality of operation of all mobile telephone systems
cannot be avoided.
12.5.1 Checking the radio coverage
The radio coverage must be tested by the service personnel after installation and before
releasing the system to the customer.
Requirement
System is in operation and the MT being used has been logged onto the system (see Section 12.4).
Hicom 150 E Office Rel.1.0 Service Manual - 12 Cordless Multicell Integration CMI
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_12.htm (13 of 45) [06/04/2000 13:05:56]