Siemens Hicom 150 E Office - Connection Requirements; Optiset E Memory

Figure 9-5 optiset E memory - standard (default) key assignments
Connection requirements can be found in Section 9.2.1.6
9.2.1.6 Connection requirements
Hardware requirements
OfficePro OfficeCom OfficePoint OfficeOne
HW requirements Free U
P0/E
port on
SLMO8/24
Free U
P0/E
port on
CBFC
SLU8
Free U
P0/E
port on
SBS
Information on upgrading peripheral board for Hicom 150 E OfficePro can be found in Section 6.1.2.
Connecting the equipment as a slave telephone
It is also possible to connect the equipment as a slave telephone (via the optiset E phone
adapter) to an existing terminal in the optiset E series (except for optiset E entry, optiset E
standard). Configurations are shown in Table 9-7).
Hicom 150 E Office Rel.1.0 Service Manual - 9 Terminals
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_9.htm (7 of 17) [06/04/2000 13:06:13]