Siemens Hicom 150 E Office - Page 247

The optiset E phone adapter (PA), optiset E ISDN adapter (TA S
0
) and optiset E analog adapter
(TA a/b) can be used only with a master terminals.
The optiset E acoustic adapter (TA AO) is supported by the optiset E comfort and optiset E
memory terminals only.
The optiset E contact adapter (TA BLCO) is supported by the optiset E basic, optiset E comfort
and optiset E memory terminals only.
You cannot connect a headset when using the optiset E control adapter (TA API) on an optiset
E basic terminal.
You cannot use an optiset E phone adapter (PA) or optiset E analog adapter (TA a/b) while the
optiset E ISDN adapter (TA S
0
) is connected.
The optiset E phone adapter (PA) and optiset E analog adapter (TA a/b) are mutually exclusive.
optiset E phone adapter (PA) and optiset E data adapter (TA 232D) are mutually exclusive.
Up to 48 (physical and virtual) optiset E key modules can be used with each SLMO24.
Please refer to Table 2-1 or the maximum number of telephones that can be connected to the
Hicom 150 E Office system. The limit values also include the slave telephones that can be
connected via the optiset E phone adapter (PA) and the analog telephones that can be connected
via the optiset E analog adapter (TA a/b).
The following model-specific maximum values apply to the optiset E adapters:
Table 9-6 optiset E for Hicom 150 E Office - maximum
number of optiset E adapters
optiset E Hicom 150 E Office
OfficePoint OfficeCom OfficePro
Key module 32 100 100
Data adapter +
ISDN adapter
8 50 50
Control adapter Unlimited quantity
Possible configurations for Hicom 150 E Office
Notes on the table:
[TA] stands for one of the following terminal adapters: TA AO, TA BLCO, TA HIO,
TA HRO.
TA 232D (SD, RS232D) means that the optiset E data adapter can be operated in
simple dialler mode (SD mode) as well as in RS232D mode.
TA 232D (SD, not RS232D) means that the optiset E data adapter can be operated in
simple dialler mode (SD mode) only.
Hicom 150 E Office Rel.1.0 Service Manual - 9 Terminals
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_9.htm (14 of 17) [06/04/2000 13:06:13]