1. For digital lines, set up an external call. If the relevant message is generated by the CO, the
date and time are set automatically.
2. In systems without digital lines, the date and time are set by means of the procedure described
above.
7.10.3 Actuators
Definition
Hicom 150 E Office provides control outputs (actuators) via an optional control relay module. This
allows the following functions to be implemented by means of codes from each telephone that is
connected:
Manual switch-on/off
Timer-controlled switching
Door opener control
Connection-controlled entrance telephone amplifier
Door busy display
Central ringing
Announcement device start/stop control
Control of external MOH applications
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x _
HW requirements Relay board Control relay module _
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 _
Dependencies/Limitations
Subject Dependency/Limitation
DISA External control also possible via the trunk.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_710.htm (4 of 19) [06/04/2000 13:07:30]
To Next Page
Loading...
