8.42 Connecting enhanced PSE radio paging
equipment (multitone) to a TMOM board
Introduction
A multitone Access 3000 with ESPA 4.4.3 protocol is installed along with a pocket receiver with a
5-digit display.
Example
Extension 100 receives the assignment for the pocket receiver.
The pocket receiver's search number is 000.
The TMOM is inserted in slot 06.
Programming with Hicom Assistant T
Step Entry Action Display
1. *95 31994 Start system administration System Administration
2. 321 Select the PSE port Sl/Le: -
3.
* 0601
Enter port Sl/Le: 0601
4. F2 Enter the PSE type Type: -
5.
* 2
Change the PSE type to "Enhanced" Type: Enhanced
6. F2 Enter the protocol Type: ESPA 4.4.5
7.
* 2
Enter protocol ESPA 4.4.3 Type: ESPA 4.4.3
8. F2 Set the operating mode Service code: -
9.
* 6
Ring type for urgent calls
(depending on the PSE)
Service code: 6
10.
F2 * 6
Ring type for normal calls
(depending on the PSE)
Service code: 6
11.
F2 * 1
Ring type for text calls
(depending on the PSE)
Service code: 1
12.
F2 * 5
Enter the code length for the call number
(depending on the PSE)
Amount: 5
13.
F2 * 2
Enter fillers for the call number (depending on the
PSE)
Fillers: Right
14.
F2 * #
Enter fillers for the call number (depending on the
PSE)
Filler: #
Hicom 150 E Office Rel.1.0 Service Manual - 8.42 Connecting enhanced PSE radio paging equipment (multitone) to a TMOM board
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_842.htm (1 of 2) [06/04/2000 13:08:57]
To Next Page
Loading...
