7.2.6 Subscriber Groups
Definition
Subscriber groups are preconfigured in the Hicom 150 E Office system. They are provided as a
common pool for the following features:
Group call (with or without busy signalling)
Hunt group (linear/circular)
Paging
The processing type for each individual group is only defined by the entry in the respective group.
This means that each of the groups can be called as a group or as a hunt group. Names can be assigned
to the individual groups via system administration.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Groups/extensions 150/20 150/20 20/8 20/8
Dependencies/Limitations
Subject Dependency/Limitation
Call forwarding When call forwarding to a group is implemented, other call forwarding operations
for individual group members are not complied with.
Call groups Individual extensions can belong to more than one group.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure groups
*9531994
2. 16-15-1 => Call Management Inc - Group Setup - Group Members
3. 16-15-2 => Call Management Inc - Group Setup - Group Type
4. 16-15-3 => Call Management Inc - Group Setup - Group Name
Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (12 of 48) [06/04/2000 13:09:58]
To Next Page
Loading...
