Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Activate do not disturb (*97)
The display shows `do not disturb'
2. Call an extension on which do not disturb has been activated. You should get a busy tone.
7.2.26 Silent Ringing
Definition
If this feature is activated from an optiset E station with a display, incoming calls are subsequently
signalled acoustically with a short alerting tone and then displayed on the display.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
General requirements optiset E with display
Dependencies/Limitations
Subject Dependency/Limitation
Silent ringing This feature can only be activated for optiset E terminals with display.
Timed reminder, automatic
wake-up system
If a user has activated silent ringing and a timed reminder is pending, it
is signalled acoustically.
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Activate the feature (*98).
The display shows `Silent Ring'.
Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (36 of 48) [06/04/2000 13:09:59]
To Next Page
Loading...
