(key or code).
The following variants of the call pickup feature also exist:
Call Pickup (PU) (on page 7-85)
Call Pickup (PU) Within Call Pickup Groups (on page 7-87)
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Camp-on A camped-on call can be picked up. If more than one call is waiting, the first extension to
place a call is always picked up.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure key for call pickup
*91 => Entry to key programming.
2. Press relevant key.
3. Assign `Directed PU' to selected key.
4. Exit key programming.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure PU key
Options
2. Set up station
3. Key programming
Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (42 of 48) [06/04/2000 13:10:00]
To Next Page
Loading...
