Siemens Hicom 150 E Office - Technical Data; Transmission Data for Hicom 150 E Officepro

Mobile telephones (with max.8 base
stations)
64 - - -
Analog telephones
250 48 16 4
Data terminals/data adapters (TA 232D)
50
3
48 8 4
optiset E control adapter
(TA API)
250
4
48 16 4
Trunks and tie trunks (total): 120 30 16 2
Trunks (digital/analog)
120 30 16 2
Tie trunks:
- digital (CorNet-N)
- analog (E&M)
120
120
30
-
-
-
-
-
Hicom Attendant P 6 6 - -
V.24 interfaces 2 2 2 1
System cabinets 3 1 1 1
1
Including mobile telephones with their own call numbers (CMI), slave telephones connected via the optiset E phone
adapter (PA) and analog telephones connected via the optiset E analog adapter (TA a/b)
2
max. 120 optiset E terminals per cabinet
3
More than 50 optiset E data adapters (TA 232D) or optiset E ISDN adapters (TA S
0
) can be connected. These
adapters reduce the maximum number of optiset E terminals by the same proportion
4
optiset E control adapters not used for CSTA applications do not count as data terminals
2.6 Technical data
Table 2-2 Technical data
Maximum system values OfficePro OfficeCom OfficePoint OfficeOne
Power consumption of PSU
*)
with connected UPSI
437 W
540 W
*)
110 W 39 W 25 W
Power consumption of UPS - 134 W 51 W -
Mains voltage 88 VAC to 264 VAC
AC line frequency 47 Hz to 63 Hz
Weight (for each fully equipped cabinet) 22 kg 8 kg 6 kg 0,7 kg
2.6.1 Transmission data for Hicom 150 E OfficePro
The transmission settings are configured on a country-specific basis using the relevant country code
entered. The following are the default values (at 220 ohms + 820 ohms II 115 nF) for Hicom 150 E
Hicom 150 E Office Rel.1.0 Service Manual - 2 System data
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_2.htm (10 of 13) [06/04/2000 13:02:34]