Routes 16 routes with
max. 72 B
channels per
route
16 routes (line
groups), 64 B
channels
8 routes with max.
all B channels per
route
8 routes with
max. all B
channels per route
No. of route keys on
optiset E
6 6 6 6
Dependencies/Limitations
Subject Dependency/Limitation
Analog trunk lines Physically disconnected analog trunk lines (loop start) must be removed from
the route.
Prime Line In the case of Prime Line on, all lines must be programmed in route 1. Prim
Line must be deactivated before another route is entered.
optiset E, route key Up to 10 route keys can be programmed on the optiset E terminal. If all lines in
a route are busy, the appropriate route lights up.
Overflow If a route is busy and an overflow for this route has been entered in the system,
an overflow to the overflow route takes place. No further overflow operation is
performed if all lines in this route are also busy.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Assign routes
*9531994
2. 17-11 => Call Management Out - Simplified Dialling
3. 17-12 => Call Management Out - Route Assignment
4. 17-13 => Call Management Out - Route Overflow
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Assign routes
Options
2. Lines / networking
3. Trunks + Routes + Routing parameters
Hicom 150 E Office Rel.1.0 Service Manual - 7.4 Features for general external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_74.htm (3 of 10) [06/04/2000 13:10:14]
To Next Page
Loading...
