Siemens Hicom 150 E Office - Translate Extension Numbers to Names for System Speed-Dialling

Dependencies/Limitations
Subject Dependency/Limitation
Analog trunk
loop start
Loop start trunks are automatically disconnected after a time period that can be set
(default= 310 seconds. 10 seconds prior to disconnection, a warning tone is sounded).
The time parameters can only be changed via Hicom Assistant E.
Configuration options
The feature can be configured using:
Hicom Assistant E
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Options
2. System Parameters
3. Flags / CMI
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Activate forward by network on an authorised terminal.
2. Call the extension under the CO extension number.
3. The call should arrive at the external destination number.
7.4.6 Translate Extension Numbers to Names for System
Speed-Dialling
Definition
In the case of calls conducted by means of system speed-dialling, the name of the destination
programmed in the system speed-dialling facility is displayed instead of the speed-dialling number
when you dial the outgoing number. If the extension number of an incoming call corresponds to an
extension number in the system speed-dialling facility, the name stored here appears on the display.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Hicom 150 E Office Rel.1.0 Service Manual - 7.4 Features for general external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_74.htm (8 of 10) [06/04/2000 13:10:14]