Siemens Hicom 150 E Office - Incoming Call; Visual and Acoustic Signalling of Dialled DID Number for Incoming Calls

Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure MUSAP key
Options
2. Set up station
3. Key programming
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Assign an extension number by means of a procedure.
2. Place an outgoing call. This number is now transmitted in the outgoing direction.
7.5.6 Visual and Acoustic Signalling of Dialled DID Number for
Incoming Calls (MSN / DID)
Definition
When an internal extension receives an external call, the original DID number that the caller dialled is
displayed. A variety of acoustic signalling methods are available for this purpose. Visual signalling is
provided by the LED assigned to the appropriate MUSAP key.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements U
P0/E
/ digital trunk board U
P0/E
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Signalling Not for S
0
terminals
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Hicom 150 E Office Rel.1.0 Service Manual - 7.5 Features for Incoming external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_75.htm (8 of 18) [06/04/2000 13:10:28]