Siemens Hicom 150 E Office - Page 477

the incoming external connection.
You can use the following features via DISA:
Direct services for internal extensions:
Send message texts, relay on/off, night service on/off, advisory message on/off, answer group
on/off, code lock on/off, do not disturb on/off, call forwarding on/off, leave/join hunt group,
reset features.
Associated services:
Advisory message on/off, answer group on/off, code lock on/off, do not disturb on/off, call
forwarding on/off, leave/join hunt group, reset features.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Analog trunk line,
Night service
Loop start trunks can be programmed for DISA access. They can be used as
normal loop start trunks during the day and then switched over to DISA
mode along with the night service function.
Call data output DISA calls are specially marked in call data output.
System speed-dialling The system speed-dialling memory can be used via DISA.
Line The line is released each time the service is activated.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Enter DISA authorisation
*9531994
2. 14-15 => Extension Data Menu - DISA
3. Configure DISA
*9531994
4. 34 -1 => DISA - Day, night
5. 34 -2 => DISA - DID number
Hicom 150 E Office Rel.1.0 Service Manual - 7.5 Features for Incoming external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_75.htm (10 of 18) [06/04/2000 13:10:28]