announcement device. This applies to both analog and digital trunk lines.
The announcement can be played either parallel to ringing or only if the call is placed in the queue.
The announcement begins after a programmable period of time and can be heard by several callers
simultaneously.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements Analog port -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
No. of callers that can listen to an
announcement simultaneously
30 30 - -
Dependencies/Limitations
Subject Dependency/Limitation
Group/extension If the announcement port is entered as a call forwarding - no answer destination,
the appropriate announcement is played if the group or extension is busy. The call
is then forwarded to the next extension or the programmed intercept criteria
apply.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure announcement before answering
*9531994
2. 25-1 => Announcement Devs. - Announcement
3. 25-2=> Announcement Devs. - Announcement type
4. 25-3 => Announcement Devs. - Ann. before answer
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure announcement before answer
Options
Hicom 150 E Office Rel.1.0 Service Manual - 7.5 Features for Incoming external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_75.htm (16 of 18) [06/04/2000 13:10:28]
To Next Page
Loading...
