3. The dialled number is in the redial memory.
4. Set up and release an internal connection.
5. The dialled external number remains in the redial memory.
7.6.2 Expanded Redial
Definition
In the case of this redial variant, the last three numbers dialled are stored. After you press the redial
key once, the last extension number dialled is redialled after a brief wait time.
You can retrieve one of the three extension numbers selectively by pressing the redial key multiple
times.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements U
P0/E
- terminal with display
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Max. number of entries 3 3 3 3
Dependencies/Limitations
Subject Dependency/Limitation
LNR DTMF signals are not regarded as dialling information and are therefore not
stored.
System speed-dialling Any speed-dialling numbers used overwrite the redial memory.
Code lock You cannot use the redial feature if the code lock has been activated
LNR The stored number can contain a total of 25 digits and the code.
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Set up an external connection.
2. Release the external connection.
3. Set up and release another external connection.
4. Press the redial key. You can switch between the stored extension numbers by pressing the
redial key repeatedly.
Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (2 of 21) [06/04/2000 13:10:45]
To Next Page
Loading...
