Check the feature for error-free functioning as follows:
Step Action
1. Configure repdial key.
2. Configure extension speed-dialling destination.
3. Dial extension speed-dialling destination (press programmed repdial key).
7.6.5 Line Seizure Type
Definition
The Hicom 150 E system permits line seizure via the line keys or call keys on an optiset terminal.
Line seizure is also possible from any terminal using the line or route codes.
When a seizure request has been detected, the system checks the availability of a free line in the route.
If a line is free, it is seized.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements Trunk board _
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Dependencies/Limitations
Subject Dependency/Limitation
Lines Nonexistent or physically disconnected lines must be cancelled in system
administration.
COS changeover Line seizure is not possible if a code lock is activated.
Entrance telephone A line cannot be seized from an entrance telephone.
Hold/park An undialled or partially dialled line cannot be parked or placed on hold.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure Prime Line on (automatic line seizure)
*9531994
Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (6 of 21) [06/04/2000 13:10:45]
To Next Page
Loading...
