Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Configure DSS key.
2. Press the DSS key. The programmed extension rings.
7.8.3 Names
Definition
Names can be assigned to each extension, to each extension group and to each route. These names are
displayed for internal calls (including CorNet-N). If an internal call does not contain extension
number information (e.g. analog CO), the relevant route name is displayed. If the incoming call
contains extension number information (ISDN), this information is displayed. See also Translate
Extension Numbers to Names for System Speed-Dialling (on page 7-117).
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Max. length of extension and group
names
16 letters 16 letters 16 letters 16 letters
Max. length of route names 10 letters 10 letters 10 letters 10 letters
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Configure extension names
*9531994
2. 14-12 => Extension Data Menu - Extension Name
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_78.htm (3 of 17) [06/04/2000 13:11:10]
To Next Page
Loading...
