Siemens Hicom 150 E Office - Enquiry; Transfer; Accept

7.11.5 Incoming Call
Definition
An incoming call via CorNet N is treated like an internal call. Digit analysis can be configured in the
network PABX in such a way that all extensions in Hicom 150 E Office can be contacted using the
relevant prefix.
The number of the extension corresponds to the external numbering plan and is analysed accordingly.
When a call is being set up, the following information is transferred to the calling remote extension:
Toll restriction
Number of the extension
Name of the extension
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x _ _
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 _ _
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1. Call a networked extension via CorNet-N.
2. If the name of the called extension is entered in the networked PABX, this will appear in the
display.
7.11.6 Enquiry / Transfer / Accept
Definition
The enquiry initiated by an extension in Hicom 150 E Office with an extension in a networked PABX
Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (7 of 17) [06/04/2000 13:11:33]