is first set up via a second B channel. If possible, the call itself is generated via path replacement (path
replacement (path optimization) is activated after connection). If path replacement is not possible, the
call remains on the second B channel.
When an external call is transferred to an extension connected via CorNet N, the extension number,
name and trunk access of extension A and C are also transmitted.
In principle, it is possible for the networked PABX to accept the call if it has been flagged as an
enquiry. If the call is accepted by the extension being consulted, the call is switched to `transit' on the
basis of the request from the main PABX and the consulting extension is released. If the enquiry
connection is released by the extension being consulted, the call is automatically switched back to the
last call held.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x _ _
HW requirements - - - -
SW requirements As of Rel. 1.0 As of Rel. 1.0 _ _
Dependencies/Limitations
Subject Dependency/Limitation
Unscreened transfer Unscreened transfer to a free or busy extension in a networked PABX is
possible.
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1.
7.11.7 Recall
Definition
A recall is performed if an unscreened transfer cannot be executed in the network. This only applies
locally and not network-wide.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x _ _
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (8 of 17) [06/04/2000 13:11:33]
To Next Page
Loading...
