7.13.7 Advice of Charge (AOC)
Definition
This feature makes call charge information available to the extension or PABX. The feature must be
provided by the public network. Two types of transmission are available:
AOC-D - Call charge information is transmitted during and at the end of the call.
AOC-E - Call charge information is transmitted at the end of the call.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
CO feature x x x x
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
AOC In some countries, pulses are transmitted instead of the amount. In this case, the pulses
received are converted to currency amounts by means of a call charge factor (as with loop
start).
7.13.8 Call Forwarding (CFW)
Definition
Three different types of call forwarding are available:
Call Forwarding Unconditional
(Call Forwarding Unconditional CFU)
All calls that are destined for an ISDN port are immediately forwarded to any port. Only one
call forwarding destination may be specified and only one call can be forwarded per
connection. Call forwarding can be activated and deactivated from the terminal with
programming authorisation and affects the entire port with DID connection (PtP), not individual
extensions. In the case of a multi-device connection, call forwarding is carried out for the MSN
which is assigned to the programming telephone. If an MSN has not been assigned to this
terminal, call forwarding cannot be programmed within the CO. None of the other MSNs are
affected by this call forwarding.
Call Forwarding Busy CFB
Same as CFU but only for busy port.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (6 of 16) [06/04/2000 13:11:53]
To Next Page
Loading...
