Siemens Hicom 150 E Office - Malicious Call Identification (MCID)

Dependencies/Limitations
Subject Dependency/Limitation
Call detail information When a CD is performed, Hicom 150 E Office does not receive any call
detail information for the deflected call.
7.13.10 Subaddressing (SUB)
Definition
Subaddressing allows the addressing capacity to be expanded regardless of the ISDN extension
number or additional information to be transmitted to the terminal dialled. It can be used to release
certain procedures.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
CO feature x x x x
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
SUB The information flows in one direction only.
7.13.11 Malicious Call Identification (MCID)
Definition
This feature makes it possible to identify unwanted callers. This must be requested from and set up by
the public network carrier beforehand. The feature is then activated in the public network. The phone
number and name of the caller are then also stored in the public network. With each incoming call the
release of the call to the called extension is delayed for a specific interval allowing the called party to
activate the feature after the caller has hung up. Release of the call is delayed only if the feature has
been requested.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Hicom 150 E Office Rel.1.0 Service Manual - 7.13 Euro-ISDN features
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (8 of 16) [06/04/2000 13:11:54]