Siemens Hicom 150 E Office - TP (Terminal Portability; Call Parking)

Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
CO feature x x x x
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
Camp-on At multi-device connections only. In the case of PABXs, camp-on is executed in the
PABX. The information element is transmitted to the CO.
7.13.16 TP (Terminal Portability / Call Parking)
Definition
It is possible to park a call on the bus, unplug the terminal, plug it in again at another location on the
bus and resume the parked call. A message indicating the portability procedure is displayed on the
parked extension. The extension is allowed three minutes to carry out this portability procedure.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
CO feature x x x x
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
TP At multi-device connections only. In the case of PABXs, the external extension is
parked in the PABX. The information element is transmitted to the CO.
TP The call must be resumed within 3 minutes.
TP This feature cannot be used with services such as telefax, teletex and data
transmission.
TP internal to S
0
In the case of a Gigaset ISDN, this feature is used for a handover between two
radio cells and for implementing the park feature. The feature is implemented by
the system.
Hicom 150 E Office Rel.1.0 Service Manual - 7.13 Euro-ISDN features
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (12 of 16) [06/04/2000 13:11:54]