Siemens Hicom 150 E Office - Ptp on the User Side; Setting National and International Codes for Outgoing Calls

CO feature - - - -
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
7.13.19 PtP on the User Side
Definition
It is possible to configure an S
0
port on the user side as a point-to-point connection, e.g. in order to be
able to use a connected fax server. The port receives an extension number with which a DID is
enabled. Call forwarding can also be configured on this port.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
CO feature - - - -
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
PtP Only the DID, CLIP, CLIR and AOC features are supported.
7.13.20 Setting National and International Codes for Outgoing Calls
Definition
The caller`s extension number is shown in the display of optiset E terminals, in the missed calls list
and in dialling aids (e. g. Smartset) depending on the origin including the trunk access code (e. g."0"),
the national (e. g. "0") or international (e. g. "00") prefix.
In general, carriers are contacted via an individual national (1-digit) and international (2-digit) prefix.
If a Hicom 150 E Office system has access to several carriers (individual port or shared port), it is not
possible to identify the carrier from which the call is originating in the case of incoming calls.
This feature makes it possible to configure national and international access codes (national and
international prefix) to enable the display of a prefix. The values of the codes that can be configured
range between "0"and "9".
Hicom 150 E Office Rel.1.0 Service Manual - 7.13 Euro-ISDN features
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (14 of 16) [06/04/2000 13:11:54]