Missed called lists and Smartset can therefore also be implemented when using carriers for answering
calls. The available prefixes are also used for the carriers.
Model-Specific Data
Subject OfficePro OfficeCom OfficePoint OfficeOne
Feature available in x x x x
HW requirements S
0
module -
SW requirements As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
CO feature - - - -
Extension feature x x x x
Dependencies/Limitations
Subject Dependency/Limitation
National or international prefix There is only one national or one international prefix system-wide.
These and therefore the codes for carriers can be set as 2-digit
codes.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1. Set codes
*9531994
2. 20-2-5 => ISDN Parameter Menu - Route tel. number - National Prefix
3. 20-2-6 => ISDN Parameter Menu - Route tel. number - Internat. Prefix
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Set codes
Options
2. Lines / networking
3. ISDN parameters
4. Enter national/international prefix
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (15 of 16) [06/04/2000 13:11:54]
To Next Page
Loading...
