Siemens Hicom 150 E Office - Cornet Networking; Networking Hicom 150 E Office with Hicom 150 E Office

8.15 CorNet networking
Introduction
CorNet networking can only be fully programmed via Assistant E (programming is restricted with
Assistant T). As a result, this section only describes programming via Assistant E.
The following networking variants are described:
Hicom 150 E Office with Hicom 150 E Office Section 8.15.1
- Networking two systems with one main CO each
- Open numbering with break out in the remote system
- Closed numbering with break out in the master system via LCR
- Closed numbering without LCR and without break out
- Closed numbering without LCR in the slave system with break out
Networking Hicom 300 with Hicom 150 E Office Section 8.15.2
- Networking with closed numbering without LCR
- Networking with closed numbering with LCR
- Networking with closed, unsorted numbering with LCR without trunk group code
Programming for all networking types Section 8.15.3
- Network-wide trunk access with allowed and barred lists
- Network-wide trunk access implemented by means of LCD restriction
- Automatic network supplier selection (call by call)
- Using the master system's system speed-dialling from the slave system
Note
If two or more OfficePros are linked in a network, the CGM module on the CBMOD of each
OfficePro must be retrofitted.
8.15.1 Networking Hicom 150 E Office with Hicom 150 E Office
Networking two systems with one main CO each
Open numbering with break out in the remote system
(Break out is the term used for an external outgoing call via the remote system's main CO)
Prerequisites for programming example
Both systems have a numbering plan containing the extension numbers 100 to 749.
Hicom 150 E Office Rel.1.0 Service Manual - 8.15 CorNet networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_815.htm (1 of 13) [06/04/2000 13:12:59]