Siemens Hicom 150 E Office - Programming Operations for All Networking Types

Programming the slave system via Assistant E
Go to Routes in the Lines/networking menu and select Route 1. Make the following settings:
Enter the route name and set the 2nd trunk code to 0, the trunk group code remains set to 0.
The route type is set to PABX in the Routing parameters window and the route telephone number
(PABX number) is set under No. and type, outgoing.
The CorNet lines are to be assigned to route 1 in the Trunks window. Double-click on the asterisk in
the Param column for the relevant line to set the protocol to S0: CorNet-N variant 1 slave (direct).
In the System Parameters window, deactivate Automatic line seizure under Flags/CMI.
Switch to the Least cost routing window and activate Release LCR.
Make the following entries in the Dial plan window:
Line 1: Dialled digit 0CZ references route table 1 (plan for trunk call)
Line 2: Dialled digit 2191 references route table 1 (plan for CorNet - extension 2191)
Line 3: Dialled digit 2193 references route table 1 (plan for CorNet - extension 2193)
Line 4: Dialled digit 2194 references route table 1 (plan for CorNet - extension 2194)
Make the following entries in Route table 1 in the Route table window:
Line 1: Route 1, Dial rule 1, Warning: NONE
Make the following entries in the Dialling rules table:
Line 1: Rule name, Rule format: E1A, Procedure: Corporate network
8.15.3 Programming operations for all networking types
Network-wide trunk access with allowed and barred lists
Notes:
Programming the parameters Release LCR, Route type and 2nd trunk code affect the toll restriction
check!
Scenario 1: LCR deactivated, no 2nd trunk code, Route type: Trunk: all digits are subject to toll
restriction in the originating system.
Scenario 2: LCR deactivated, 2nd trunk code, Route type: PABX:
Scenario 3: LCR deactivated, 2nd trunk code, Route type. Trunk: all digits are subject to toll
restriction in the originating system.
Scenario 4: LCR deactivated, 2nd trunk code, Route type: PABX: all digits after the 2nd trunk code
are subject to toll restriction in the originating system.
Scenario 5: LCR released, no 2nd trunk code, Route type: Trunk: all digits undergo the toll restriction
check in their own system.
Hicom 150 E Office Rel.1.0 Service Manual - 8.15 CorNet networking
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_815.htm (8 of 13) [06/04/2000 13:12:59]