Siemens Hicom 150 E Office - Configuring an Internal S0 Bus with Multiple Extensions

To Next Page

To Previous Page

8.18 Configuring an internal S0 bus with multiple

extensions

Introduction

Each S

bus can support up to 8 terminals or telephones. For this purpose, one or more system ports

must be configured as a ISDN bus.

Example

Port 4 is to be configured as a ISDN bus.

Programming with Hicom Assistant T

Step Entry Action Display

1. *95 31994 Start system administration System Administration

2. 20 -4-1

ISDN Parameter Menu, EU Parameter Menu, S

Port

Config.

Port 1: ISDN Public PP

# 4

Select Port 4 Port 4: ISDN Public PP

* 4

Configuration as an ISDN bus Port 4: ISDN Bus

5. F8-F7 Exit system administration Set time, Set date

Programming with Hicom Assistant E

Step Action

1. Options -> Lines / networking -> Trunks -> Flags

Note

LS numbers must now be assigned for each telephone or terminal connected to the ISDN bus. How

the LS is set on the telephone depends on the particular phone.

If no LS is assigned for the telephones, the default setting for this port is used as the LS for all

telephones, i.e. when this default LS is called, all the telephones connected to the bus are called.

Other manuals for Siemens Hicom 150 E Office