Siemens Hicom 150 E Office - Names; Configuring a Door Busy Actuator

To Next Page

To Previous Page

8.22 Configuring a door busy actuator

Introduction

You can control an external door busy display by means of an actuator.

Example

Actuator 1 is to be configured as a busy display for the entrance telephone.

Extension 19 must already be configured as an entrance telephone.

The name "Door busy" is to be assigned to actuator 1

Programming with Hicom Assistant T

Step Entry Action Display

1. *95 31994 Start system administration System Administration

2. 26-1 Select the Type submenu in the Actuator Setup

Actr No.1:-

* 5

Change the parameter in the Engaged Display Actr No.1: Engaged Display

F2 * 1

Define the actuator's react time in the React Time

submenu

Actr No.1: 1

F2 * 19

Enter the doorphone extension in the "Assigned

ext." submenu

Actr No.1: 19

6. F2 *

Engaged

Assign the name of the actuator in the "Actuator

name" submenu

Actr No.1: Engaged Display

7. F8 F7 Exit system administration Set time, Set date

Programming with Hicom Assistant E

Step Action

1. Options -> Trunk modules -> Actors

Note

An external busy display must be connected to the actuator's NO contact for the purpose of signalling.

Current carrying capacity of contacts, see Tabelle 3-42

React time = entered value x 100 ms

Hicom 150 E Office Rel.1.0 Service Manual - 8.22 Configuring a door busy actuator

http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_822.htm (1 of 2) [06/04/2000 13:13:25]

Other manuals for Siemens Hicom 150 E Office