Siemens Hicom 150 E Office - Hicom 150 E Office - Hicom Agentline Office Call Distribution

To Next Page

To Previous Page

8.32 Hicom 150 E Office - Hicom Agentline Office

call distribution

Introduction

This section describes the configuration of the Hicom 150 E Office for combined UCD with Hicom

Agentline Office.

Call numbers and the associated names that can be used for Hicom Agentline Office UCD groups are

limited on the system side to 60. The last 60 call numbers in the group must be used for this, e.g. the

default call number 440 - 499 in OfficePro.

Any valid call number for which no terminal is available in the system can be used for priority

dialling in the system.

For this, the call number must reference the same call destination list for priority dialling with the

associated UCD group call number. In this call destination list, the 1st call destination is the relevant

UCD group.

A call destination list is defined for the peak phase in which the "UCD group 60" is entered as the first

call destination. This group is used for the central queue field. This group should be entered as the

overflow destination for every other UCD group. This means:

that the 1st call destination is the relevant UCD group and

that the 2nd call destination is the UCD group for the central queue field.

Example

The following example describes a configuration containing two UCD groups in addition to 3 priority

dialling numbers. There are 2 agents operating in each group.

Assigning Agent IDs to groups

UCD group 1 is the purchasing department and is to be assigned the group IDs 100 and 101.

UCD group 2 is the sales department and is to be assigned the group IDs 110 and 111.

Programming with Hicom Assistant T

Step Entry Action Display

1. *95 31994 Start system administration System Administration

2. 31-1 Activate Group Setup Agent 100: -

Assign UCD group 1 Agent 100: 1

Select the next ID Agent 101: -

Assign UCD group 1 Agent 101: 1

Hicom 150 E Office Rel.1.0 Service Manual - 8.32 Hicom 150 E Office - Hicom Agentline Office call distribution

http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_832.htm (1 of 5) [06/04/2000 13:14:25]

Other manuals for Siemens Hicom 150 E Office