8.38 Analog tie traffic via TIEL boards
Introduction
Analog tie traffic is possible with the TIEL board.
Example
Two Hicom 150 E OfficePros are networked via the TIEL board.
Board constellation of both systems:
Slot 2 = SLMO 24
Slot 3 = SLMO 24
Slot 4 = SLA16
Slot 5 = free
Slot 6 = STMD8
Slot 7 = TIEL
Both systems have a system interface.
STMD port 1 is assigned to route 1.
TIEL port 1 is assigned to route 2.
Programming with Hicom Assistant T
Step Entry Action Display
1. *95 31994 Start system administration System Administration
2.
16-20 * 1
Release DID DTMF for TIEL port 1 Sl/Le 0701: Allowed
3.
F8 17-12 # 0701
* 2
Assign TIEL port 1 to route 2 Sl/Le 0701: 2
4.
F8 20-2-1 * 98462
STMD port 1, assign system number Rte 1: 98462
5.
F2 * 2302
STMD port 1, assign national number Rte 1: 2302
6.
F2 * 49
STMD port 1, assign international number Rte 1: 49
7.
F2 * 1
STMD port 1, assign type of no., orig. Rte 1: local
If necessary, assign route names:
8.
F8 17-15 * ISDN
Route STMD port 1, Route 1
Name -> ISDN
Rte 1: ISDN
Hicom 150 E Office Rel.1.0 Service Manual - 8.38 Analog tie traffic via TIEL boards
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_838.htm (1 of 2) [06/04/2000 13:14:39]
To Next Page
Loading...
