Siemens HiPath 1130 - Permissions for a Door Opener

Entrance Telephone
101
Step by Step
Permissions for a Door Opener
Different extensions can be individually enabled to
activate the Door Opener.
This class of service is assigned to all extensions by
default.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot for the extension configured as the Door
Opener (1 to 4).
... Enter the extension numbers (e.g., 12/102) to be
enabled as Door Openers.
Delete extensions enabled for opening doors.
Press this key.
Initial state for Programming Mode.
Deleting Authorized Extensions
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot for the extension configured as the Door
Opener (1 to 4).
Delete the extension assigned to the Entrance
Telephone slot.
Press this key.
Initial state for Programming Mode.
2 5
1 4
*
#
2 5
1 4
*
#