Siemens HiPath 1130 - Fax Reception Extension

Fax/DID Module
111
Step by Step
To a c t i va te
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog or digital line
(e.g., 801).
... Select the operating mode for the line:
= Module is deactivated
= Fax
= DID
= Fax/DID
= Announcement
= AutoFax
Enter the number for the next external line available.
or
Press this key.
Initial state for Programming Mode.
To d e a c t i v a t e
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog or digital line
(e.g., 801).
Enter the code for deactivating Fax/DID reception.
Enter the number for the next external line available.
or
Press this key.
Initial state for Programming Mode.
Fax Reception Extension
After the detection of a fax signal, the Fax/DID Module
can transfer a call to a preconfigured extension. The DID
Mode does not need to be configured for this feature.
2 7
0 5
0
1
2
3
4
5
#
2 7
0
#