Step by Step
ADSL Module
126
ADSL Module
The ADSL module allows you to connect PCs to a
network and have them share the ADSL access without
requiring a splitter, ADSL modem, hub or any additional
network cards. To share access simply install the
module in one of the PCs.
The PCs are connected to the HiPath 1100, which
provides the same functions as the V.24 serial interface
via LAN. This capability is used for integrating applica-
tions such as the HiPath 1100 Manager, Interaction
Center Smart and CDR applications. ADSL access must
be enabled by a carrier for one of the lines. An Internet
provider is also required.
To configure the ADSL module correctly you need infor-
mation about the ADSL protocol, the carrier’s VPI/VCI,
the provider’s DNS servers, user name and password.
This information is entered in the HiPath 1100 ADSL
Manager Administrative software for configuring the
module correctly.
All the PCs must have a network card installed and be
on the same network as the ADSL module used as a
gateway for accessing the Internet (the default IP is
10.0.0.1). For example, a network with IP addresses
from 10.0.0.2 to 10.0.0.10 and subnet mask
255.255.255.0.
English (IM) - Venezuela 58
India 91 Vietnam 84
Italy 39 - -
Do not connect a V.24 interface adapter cable to
the switch when using an ADSL module. All data
is delivered through the network. Remember to
configure the Communications Server for the
network connection.
Country CAC Country CAC
To Next Page
Loading...
