Siemens HiPath 1130 - Restoring the ADSL Module Default Settings; Relay and Sensor on the Hipath 1120; Sensor; Programming the Sensors Function

Relay and Sensor on the HiPath 1120
127
Step by Step
Restoring the ADSL Module Default
Settings
This code restores the default configuration of the
ADSL module assuming an IP of 10.0.0.1.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Initial state for Programming Mode.
Relay and Sensor on the
HiPath 1120
You can connect a Music module to the HiPath 1120
system. This module also provides a Relay and a Sensor
for integrating other devices such as an Entrance
Telephone, a Door Opener, alarms, etc.
Sensor
When the state of the sensor contact changes, for
example, when an open contact closes, the following
functions can be executed:
• Selection of a number in the Speed Dialing Phone-
book
• Activation of a relay
• Select a number from the Speed Dialing phonebook
and activate the relay.
The activation logic based on the initial position of the
sensor contacts and its resulting actions are program-
mable.
Programming the Sensor’s Function
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Select the sensor’s function:
1 30
7 0
0 3